Operation Guide

There are 2 ways to power your lighting system from a remote
location or if a 120/240volt AC power outlet is not available.
1. A common household portable power pack, (otherwise called an automotive jumpstart box) with an AC outlet can be
used as a power source for the included AC adapter.
2. A 20-24volt DC power source, such as two 12volt batteries connected in a series circuit (positive terminal of one battery
connected to the negative terminal of the other, with the remaining terminal from each battery properly connected to
the light arc wiring harness).
• Be sure the adapter is disconnected from power source.
• Cut the wires near the 120/240volt adapter leaving enough length to rejoin if necessary. You may consider installing a
suitable connector to switch back and forth.
• Install a 1 amp fuse and suitable terminals to make a proper connection to the battery
• Identify the negative wire (-) by the dashed white lines. Connect this wire to the battery
negative terminal.
• Connect the remaining positive wire to the fused battery positive terminal.
• Plug the harness into the light arcs, Note the red "ON" indicator light in each arc, Chronograph
is ready to use.
Limited Warranty
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
COMPETITION ELECTRONICS, INC. warrants the product manufactured by it to be free from defects in material and workmanship for a
period of 2 years from date of purchase by the original purchaser for use. COMPETITION ELECTRONICS, at its option, will repair or
replace without charge, or refund the purchase price of, any product which fails during the warranty period by reason of a defect in
material or workmanship found upon examination by COMPETITION ELECTRONICS, INC., to have been the cause of failure. This warranty
does not cover any failures attributable to abuse, mishandling, failure to follow operating instructions, alteration or accident.
To make claim under this warranty, the purchaser must return the product to COMPETITION ELECTRONICS, INC., at the address shown
below, properly packed and with shipping charges prepaid. All claims must be made in thirty (30) days after the product failure and, in any
event, within thirty (30) days after the expiration of the 2 year warranty. All claims must be accompanied by a sales receipt or other written
proof of date of purchase.
TO THE EXTENT PERMITTED BY LAW, ANY AND ALL IMPLIED WARRANTIES, INCLUDING MERCHANTABILITY AND FITNESS FOR
PARTICULAR PURPOSE, ARE EXCLUDED; ANY IMPLIED WARRANTIES NOT EXCLUDED ARE LIMITED IN DURATION TO 2 YEARS FROM
DATE OF PURCHASE. INCIDENTAL AND CONSEQUENTIAL DAMAGES ARE EXPRESSLY EXCLUDED FROM THE REMEDIES AVAILABLE
TO PURCHASER, AND THE REMEDIES PROVIDED IN THIS WARRANTY SHALL BE EXCLUSIVE TO THE EXTENT PERMITTED BY LAW.
(Note: Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or
consequential damages, so the foregoing limitations and exclusions may not apply to you. This warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.)
If any product returned by the purchaser is found by COMPETITION ELECTRONICS, INC., to require service not covered by warranty,
COMPETITION ELECTRONICS, INC., will so advise the purchaser and request further instructions.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
12v 12v
1 AMP FUSE
POSITIVE (+)
NEGATIVE (–)
CONNECT TO
WIRE HARNESS
815.874.8001 • competitionelectronics.com
Full Service &
Support.
2 Year Warranty
Designed
& Built
in the USA
Competition Electronics • 3469 Precision Drive, Rockford, IL 61109 • PHONE [phone] • FAX [phone]