User`s manual

CompeGPS Team S.L.
http://www.compegps.com
http://support.compegps.com
Besides, from this option, you may configure the order in which the degrees will be displayed.
By default, TwoNav Works with Lat / Long and Datum WGS84 Coordinates.
4.9.11 Time zone
„Main menu > Settings > System > Time zone‟
TwoNav lets you choose the time it is according to the Universal Time Coordinates (UTC) that will
appear by default with the time-zone corresponding to the Central European Time (CET).
You may also set the Summer Time automatically if you wish, so TwoNav carries out the
seasonal time change.
Note: TwoNav keeps the time updated as long as the device receives a GPS signal. Usually,
inside the buildings, the signal from the satellites is not received unless there is a repeater, so the
time and also the, night vision, will be affected.
4.9.12 Default settings
„Main menu > Settings > System > Default settings‟
This option lets you re-establish all the settable parameters to its initial status. All the options that
have been manipulated will be modified, time zone, volume, folders and other tools that you may
have previously established.
4.9.13 Update OS
„Main menu > Settings > System > Update OS‟
When an Operating System update is available at www.compegps.com or www.twonav.com , you
will have to use this button to complete the update in your device.
See instructions in web download area to know the exact steps to follow.
4.9.14 Device ID
„Main menu > Settings > System > Device ID‟
The „Device ID‟ is an alphanumeric identifier exclusive to your device. This identifier is necessary
in order to activate TwoNav and any map you want to use in the device.
4.9.15 About
„Main Menu > Settings > System > About‟
„About‟ shows you which TwoNav version the device is working with. It will be displayed on the
top left hand corner of the screen.
To know the version of the TwoNav program installed in your device, it is very important to check
out doubts or software updating.
4.9.16 Advanced
„Main Menu > Settings > System > Advanced‟
TwoNav has and „advanced mode‟ which enables some extra functions that are not frequently
used and could add unnecessary complexity to the system.
You can enable „advanced mode‟ entering „Settings > System > Advanced‟ section. Then some
advanced functions will appear directly inside that section: