User`s manual

CompeGPS Team S.L.
http://www.compegps.com
http://support.compegps.com
4.9.4 Language
“Main Menu > Settings > System > Language”.
You may modify the language of the texts and voices of the system from this section.
Note: The conversion of the voices may take more than one minute.
4.9.5 Calibrate screen
„Main Menu > Settings > System > Calibrate Screen‟
The option „Calibrate screen‟ lets you correct all the little maladjustments that the touch screen
may have, that is to say, that you press on one spot and the reactions does not appear on this
concrete spot, but a little misplaced.
When calibrating the screen, the following instructions message will be displayed:
“Press and briefly hold stylus on the center of the screen and repeat as the target moves around
the screen. Press Esc to cancel”
Click briefly with the stylus on the centre of the cross and repeat as the objective moves across
the screen.
Once the new screen calibration is done, the following message will be displayed:
“New calibration settings have been measured. Press Enter key to accept the new setting. Press
the Esc key to keep the old settings”
Press on the screen to end calibration.
4.9.6 Barometer calibration
„Main menu > Settings > Off-road > Calibrate Barometer‟
The errors on the setting of the pressure may cause wrong readings of the altitude.
By default, the barometer will be calibrated automatically by means of the altitude data supplied
by the GPS using an algorithm that will optimize its function.
If you wish, you may calibrate the barometric altimeter manually from „Main Menu > Settings >
Off-road > Barometer Calibration‟ introducing the present altitude with the keypad that will be
displayed when pressing this option.
In order for this manual calibration not to be altered by the automatic calibration process, you
must set TwoNav to take the altitude by only taking the barometer reading.
4.9.7 Compass calibration
„Main Menu > Settings > Off-road > Compass Calibration‟