User manual

http://www.CompeGPS.com http://Support.CompeGPS.com 73
 Show 'Trip review' when stop recording 'Triplog': 'Trip review'
(properties of the recorded track) is not shown after the current ‘Triplog’ is
stopped.
 Reset 'Triplog' recording when changing navigation: When a new
navigation is started, the recording of a new track is also started ('Triplog').
Note: TwoNav synchronizes at the same time the recorded track, the recorded
data fields and navigation (destination) to simplify the general use of the
application, but in some cases, you may prefer that some synchronization points
are disabled.
8.10 Autonomy
Maximize the autonomy of your device while running TwoNav:
 Battery level
 Shutdown screen: Time interval to automatically switch the screen off.
 Do not shutdown if plugged: If enabled, screen shutdown time is not
applied, leaving the device with the screen on during all the trip.
 Disconnect GPS if minimize: GPS behaviour when TwoNav is
disconnected if minimized.
 Connection interval: Improve the autonomy of the device by setting the
connection interval of the GPS.
 Disconnect GPS when stop: TwoNav will detect a stop in your itinerary
and will automatically disconnect the device.
8.11 Communications
8.11.1 ANT+™ accessories
Only iPhone/iPad devices: Your device is ANT+™ certified and compatible with
ANT+™ heart rate monitors, bike cadence sensors, bike speed sensors and bike
speed/cadence combo sensors.
Once the sensors are in place, select ‘Activate HR/Cad/SSp’. Then, the device
will start looking for the sensor signal. If it is available, it will be displayed. Data is
also stored for each recorded track point.
Important: Analyse all the information recorded by ANT+™ sensors using
Land/Air software (Windows/Mac platforms), more information at
http://www.CompeGPS.com