User manual

http://www.CompeGPS.com http://Support.CompeGPS.com 70
8.8.2 Next waypoint
When navigating a route, you can select a required event to validate a waypoint
and switch to the following one:
 Radius of the next waypoint: Enter inside the radius of the next waypoint
(only that one).
 Radius of any next waypoint: Enter inside the radius of any of the next
waypoints (next one and any of the succeeding waypoints).
 Roadbook mode: When entering the radius of any waypoint, it will be set
as next. When going out of it, next one will be activated. When following a
roadbook it is required to show the information of the current waypoint
while in its surroundings. This way, instructions for each point can be
followed correctly.
 Bisector inside next waypoint: Enter inside the radius of next waypoint
and cross the bisector that is formed with the previous and next waypoint.
 Bisector inside next waypoint or 10% of any waypoint: Same as the
previous, but if any waypoint is quite near (10% of its radius) it will be
validated and the next one will be activated.
 Only buttons bar: Never change to next waypoint automatically, only
manually when 'Next waypoint' or 'Previous waypoint' buttons are pressed.
A default radius can be assigned for route waypoints, this value will be taken
when this information is not available. If radius for a concrete waypoint of the
route is defined, it will be respected. But in case that waypoint does not have a
specific radius, the default one will be used instead.
8.8.3 Estimated times
Configure the preferences to automatically calculate the estimated time of
destination arrival:
 Use V-Map’s routing speed (only in ‘On-Road’ mode): Calculates the
estimated time of arrival taking into consideration the speed of the route.
 Use navigated track time (only in ‘Off-Road’ mode): Calculates the
estimated time of arrival taking into consideration the time of the track.
 Interval for partial mean speed: Calculates the estimated time of arrival
taking into consideration the partial mean speed of the selected interval of
time.