User`s manual

Additional Printing & Configuration Options 8-2

8. Press the ENTER key and a cursor will appear under the last digit of the IP

address.

9. Press the

key to move the cursor to the desired digit to change.

10. Press

to change the value of a digit.

11. Once all digits are set to the desired values, press the ENTER key to accept the

new address.

12. Repeat steps 7 - 11 for Subnet Mask and Default Gateway (the router’s IP

address). If unsure of the correct Subnet mask and the first number in the 3000E

IP address is from 192 to 254, then use 255.255.255.0 as the Subnet mask.

13. When all settings for IP Address, Subnet Mask, and Default Gateway are com-

pleted, press the

key to return to the Option submenu (TCP/IP is displayed).

Note: It is recommended to turn off protocols that are not in use, however, be aware that

the management and print capabilities which depend upon that protocol will no

longer function. For example, if the Novell protocol (IPX) is turned off, then Net-

Ware printing, management with the MAP utility, and IPX Peer to Peer printing

will all be disabled.

14. Optional: Press

to display the protocol to turn off, e.g. EtherTalk.

15. Optional: Press the ENTER key and a ? will appear next to On.

16. Optional: Press

to toggle the value to Off and press ENTER to accept the

new value.

17. When completed, press the MODE key to exit the menu system.

18. Press the STATUS key to print a status page and verify the new settings.

8.1.1 Firmware Requirements for Front Panel Setup

Following are the firmware levels required for front panel setup capability. The

firmware level of the printer is listed as Software version on the printer status page.

FS/LS-800 requires version 38.01 or later

FS/LS-1700+ requires version 40.00 or later

FS/LS-3700+ requires version 32.02 or later

FS/LS-7000 requires version 25.07 or later

FS/LS-5800C, 6700, 7000+, 9000 all versions

Cover-Preface.book Page 2 Wednesday, May 12, 1999 10:48 PM