User`s manual

Additional Printing & Configuration Options 8-1

Additional Printing & Configuration Options

8.1 EcoLAN 3000E Setup Using the Printer Front Panel

The printer front panel may be used to set a number of 3000E parameters including:

Turning On or Off the network protocols.

Setting the Novell (IPX) frame type.

Enabling or Disabling DHCP.

Setting the IP Address, Subnet Mask, and Default Gateway.

The following procedure explains how to set the IP address, Subnet Mask, Default

Gateway and disable unused protocols:

Note: Setting the IP address with the front panel automatically sets IP Persistence to Per-

manent, that is, the IP address is maintained when the printer is turned off and on.

1. Press the MODE key.

2. If the first line of the LED panel does not already display INTERFACE, press the

key until INTERFACE is displayed.

3. If the line below INTERFACE does not already display OPTION (OPTION 2 on

the FS-7000), press the ENTER key, then

until OPTION is displayed and

press ENTER.

4. Press the

key to enter the Option submenu. (Note: Not all firmware versions

support front panel setup. If there is no Option submenu or not all choices are

available on the submenu, please check the firmware version requirements listed

in the following section.)

5. Press

until TCP/IP is displayed.

6. Press the

key to enter the TCP/IP submenu (the TCP/IP submenu is accessible

only when the TCP/IP protocol is On).

7. Press

until IP Address is displayed.

Cover-Preface.book Page 1 Wednesday, May 12, 1999 10:48 PM