User`s manual

Hardware Installation 2-1
2
Hardware Installation
2.1 Supported Kyocera Printer Models
The EcoLAN 3000E is compatible with the FS or LS-600, 680, 800, 1700+, 3700+,
6700, 7000+, 9000 and any other Kyocera printer with the new slide-in interface.
The EcoLAN 3000E is NOT compatible with previous FS/LS-Series models,
including, FS/LS-400, 850, 1500/A, 1550/A/+, 1600/A/+, 1700, 3400/A/+, 3500/A,
3600/A/+, 3700, 5500, 6500/+.
The EcoLAN 3000E is compatible with the FS/LS-7000 with a Software version of
25.05 or later. The Software version is displayed on the printer status page. The FS/
LS-7000 also includes an older daughter board style interface in addition to the slide-
in interface. The slide-in interface on the FS/LS-7000 may be used for either
a
network interface card or
an optional hard drive. Thus, if the EcoLAN 3000E is
installed in the FS/LS-7000, there is no available slot for the optional hard drive.
2.2 EcoLAN 3000E Hardware Installation
The EcoLAN 3000E is a new slide-in interface board which does not require the
removal of the printer’s main board for installation. This section includes instructions
for installation into 1) the FS-680, and 2) the FS/LS-7000+. These instructions would
be similarly applicable to comparable Kyocera printer models with the slide-in
interface.
Cover-Preface.book Page 1 Wednesday, May 12, 1999 10:48 PM