User`s manual

Jumper Settings Appendix A-2
EcoLAN 3000E Jumper Diagram
1. Power off the printer and remove the EcoLAN 3000E from the printer. The
removal process is the reverse of the installation process in Chapter 2.
2. Locate the OP2 Jumper. See jumper location diagram above.
3. Move this jumper to the FACT position, so that the jumper covers the center pin
and the pin nearest the FACT jumper designator.
4. Install the EcoLAN 3000E as shown in Chapter 2. Do not connect the printer to
the network.
5. Power on the printer. The EcoLAN 3000E performs its diagnostic self tests. The
green LED blinks 3 times then goes into an alternating green/amber light
sequence. When you see this pattern, power off the printer.
6. Remove the EcoLAN 3000E from the printer.
7. Move the OP2 jumper back to its CUST position, so that the jumper covers the
center pin and the pin nearest the CUST designation.
8. Reinstall the EcoLAN 3000E according to Chapter 2.
Cover-Preface.book Page 2 Wednesday, May 12, 1999 10:48 PM