User`s manual

Additional Printing & Configuration Options 8-8
Note: Changing the IP address with Telnet causes IP persistence to be automatically set
to Permanent. See the DHCP section for more information on IP persistence.
1. At the Main Menu, type 1 and press ENTER to bring up the IP Parameters menu
(shown on the next page).
2. Type 1 again and press ENTER. The IP Address submenu will appear:
3. Enter a new IP Address and press ENTER. Repeat the previous steps to change
Subnet Mask and Default Gateways.
4. Enter 4 to change the base port number.
Note: The base port number is one less than the actual TCP/IP port number used by the
printer. For example, to set the port number to 10001, enter10000.
8.4.3 Select Printer Languages
Selection 2 in the Main Menu allows you to designate which emulations (printer
interpreter languages) the printer supports. This is to allow the resident lpd to modify
files intended for other emulations so that they may be printed. The menu also allows
you to enable or disable banners attached to lpd handled jobs.
The emulation choices are Printer Control Language (PCL), PostScript (PS), ASCII
(simple text) and Other (any print job not recognized as PCL, PS, or ASCII). The file
modifications and conditions are:
The Configuration Utility
Unit Serial no. 221963
1. IP Address 199.92.187.37
2. Subnet Mask 255.255.255.0
3. Default Gateway 199.92.187.254
Cover-Preface.book Page 8 Wednesday, May 12, 1999 10:48 PM