User`s manual

Additional Printing & Configuration Options 8-7
8.4.1 Making the Connection
1. At the prompt, type:
telnet <network interface card IP address>
2. When login: appears, type guest if you are only interested in browsing the menus
or sysadm if you want to change the configuration. Press ENTER. When pass-
word: appears, again type guest or sysadm and press ENTER.
3. The main menu is displayed. This utility lets you change the IP Parameters, lpd
printers, protocols, restore to factory defaults, and change password. Press the
number for the parameter you wish to check or change and press ENTER.
4. To end your Telnet session, type E at the Main Menu. If you have made any
changes you are prompted to either Save Changes and Exit or Exit Without Saving
Changes. Choose your option and press ENTER.
Note: Press ? to access the Telnet help utility.
8.4.2 Configure IP Parameters
Although the EcoLAN 3000E must have an IP address before a Telnet Connection can
be made, you can use the utility to change the address or the other IP parameters. The
EcoLAN 3000E will automatically initiate a soft reset when the IP address change is
sensed. This will cause the Telnet connection to be broken. It is advisable to make all
other desired changes before changing the IP address.
The Configuration Utility
Unit Serial no. 221963 V4.10
Main Menu
1. IP Parameters
2. LPD Printers
3. Protocols
4. Restore Factory Defaults
5. Change Password
E. Exit
Cover-Preface.book Page 7 Wednesday, May 12, 1999 10:48 PM