Specifications

Fiber Optic Product
Fiber Optic Product
s
s
T
T
el (toll free): 888-785-7393
el (toll free): 888-785-7393
!
!
Fax: 508-660-0339
Fax: 508-660-0339
!
!
mailus@pulsewan.com
mailus@pulsewan.com
!
!
www
www
.pulsewan.com
.pulsewan.com
31
31
Equipment Order Number
Due to the complexity of this system and the
many modular channel options for Data, LAN,
Voice and Video, please call or email Pulse
with your requirements
FOM Fiber Modem Series
The FOM line of fiber optic modems extends the range of data transmission
beyond that of any other copper wire modem. Speeds up to 45Mbps are
supported. The FOM Series extends the distances of:
"Async "Sync "T1/E1 "T3/E3
"V.35 "RS-232 "RS-530 "X.21
"V.36 "RS-449 "G.703 "Ethernet
Equipment Order Number
Due to the many ordering options and
choices, please call your nearest Pulse office at
tel: 888-785-7393 or email: mailus@pulsewan.com
LRS-24 "Last Mile" SNMP Modem Rack
LRS - 24 is high-density SNMP managed modem hub. The chassis has 12
slots that accommodate up to 24 modems. Using modular interface cards LRS
- 24 can support xDSL, fiber or baseband modems in the same chassis under
a single management application.
The system supports different modem technologies and enables a wide range
of data rates starting from 1.2 kbps in IDSL modems through 2 Mbps in HDSL
modems, and up to 43 Mbps in fiber modems. These modem technologies
enable ranges from 4.8 km at 2 Mbps over copper to 100 km over fiber optic
cables.
All cards can be replaced, or cables removed, during operation, without
causing interference to data transmission to/from other cards in the chassis.
Modular data interfaces allow modem connectivity using a wide range of data
interfaces. These include V.24, V.35, X.21, RS-530, V.36, G.703 Codirectional,
E1/T1, built-in Ethernet bridge (with or without VLAN support) and built-in IP
router.
LRS-24 accepts a system clock via the DB-15 connector placed on the CM-2
card and distributes the clock to all cards.
FLM Fiber Multiplexer Series
The FLM line of fiber optic Time Division Multiplexers enables up to 48 async
terminals or workstations to be multiplexed onto a dual fiber optic cable.
Synchronous transmission is available with the FLM-2.
Equipment
Order Number
FLM-1 6/12 Channel / ST RFLM1SADFST115
FLM-2 6/12 Ch/sync / ST RFLM2SADFST115
FLM-3 48 Channel / ST RFLM3ST115
Call for more options.
FOM Series
FLM-2
Extend
Extend
Data, Voice
Data, Voice
and Video
and Video
!
!
LRS 24