Instruction manual

ATLAS 800 Series System Manual System Config Menu Descriptions

SNMP

Write security: 3; Read security: 5

Provides a way to configure SNMP access for the ATLAS. The following options are available for review

and editing:

SNMP Access Defines whether SNMP access to the ATLAS is enabled or disabled. Select the

appropriate option.

SNMP Communities Defines SNMP manager(s) characteristics as follows:.

Trap Transmission Enables and disables SNMP trap transmission.

Authen Trap

Transmission Enables and disables the authentication failure trap.

Traps Destination Defines the destination for SNMP traps as follows:

Submenus Description

IP Address

Specifies the IP address of the network manager.

Privileges

Defines the GET (read-only) and GET/SET (read and write) privileges.

Get Name

Defines the community name for GET access. This value must match the GET

name defined on the network management station.

PUBLIC is the default name.

Set Name

Defines the community name for SET access. This value must match either the

GET or SET name defined on the network management station. PUBLIC is the

default name

Submenus Description

IP Address

Identifies the IP address for the network manager (NM) to sends traps.

Community Name

Defines the community name for trap destinations. This name must match the

community name defined on the NM.

Trap Filtering

Sets the minimum severity level required for a system event to generate an

SNMP trap. If a trap event occurs with a security level equal to or more severe

than the trap type’s current threshold setting, the event is sent as an SNMP trap.

(Refer to the ADTRAN Technical Support web page (www.adtran.com

) for a

listing of all MIBs containing traps and their security levels.) The following

threshold levels for the available selections:

DISABLED, CRITICAL, MAJOR,

INOR, WARNING, NORMAL, and INFO.

Station Type

To deliver the SNMP trap packet with the COMMUNITY NAME unchanged, define

E STATION TYPE as NORMAL. If you are using T-Watch PRO, define the STATION

YPE as T-WATCH MGMT and append the COMMUNITY NAME with “.ADLP

ADDRESS.” Within the SNMP trap packet, this field is automatically updated

before it is sent to the management station.