Instruction manual

ATLAS 800 Series System Manual Installing Network and Option Modules

Network Turnup Procedures

Modules Installation Instructions

1. Remove the cover plate from the appropriate option slot of the ATLAS rear panel.

2. Slide the option module into the option slot until the module is firmly seated against the front of the

chassis.

3. Secure the (thumb)screws at both edges of the module. Tighten with a screwdriver.

4. Connect the cables to the associated device(s).

Modules Shipping Contents

Quad T1/PRI Option Module (P/N 1200185L3)

• Quad T1/PRI Option Module

• Quad T1/PRI Option Module Quick Start Guide

• Four cables (RJ-48C to RJ-48C), ADTRAN P/N: 3125M008

• Two cross-over cable (RJ-48C to RJ-48C), ADTRAN P/N: 3125M010

• Two DB-15 to RJ-48 Adapters, ADTRAN P/N: 3196027

Quad E1/PRA Option Module (P/N 1200264L1)

• Quad E1/PRA Option Module

• Quad E1/PRA Option Module Quick Start Guide

• One DB-62 to Quad DB-15 female cable, ADTRAN P/N: 3125I061

Quad Nx 56/64 Option Module (P/N 1200184L1)

• Quad Nx 56/64 Option Module

• Quad Nx 56/64 Option Module Quick Start Guide

• Two DB-37 to V.35 converter cables, ADTRAN P/N 1200784L1

Option modules are intended to be serviced by qualified service personnel only.

The Quad E1/PRA Option Module may also be purchased with BNC Network Connection Interfaces

(P/N 4200264L1).