Instruction manual

ATLAS 800 Series System Manual

3. Configure the modem as follows:

• 9600 baud rate

• 8 data bits

• No parity

• 1 stop bit

• Flow control - Hardware

• Auto Answer - On

• DTR - Idle (when Off/normal on the modem with ATLAS in dial mode)

4. ATLAS 830

Connect the male DB-9 connector of the data cable to the female DB-9 connector, labeled A

DMIN,

located on the back of the unit.

ATLAS 890

Connect the male RJ-45 connector of the data cable to the female RJ-45 connector, labeled A

DMIN,

located on the back of the unit in the middle of the S

YSTEM CONTROLLER module.

5. Route the data cable to the modem.

6. ATLAS 830

Connect the other end of the cable to the DB-9 end of the connector (DB-9 to male DB-25). Then,

connect the DB-25 end of the connector to the modem, configured as described above.

ATLAS 890

Connect the other end of the cable to the RJ-45 end of the connector (RJ-45 to male DB-25). Then,

connect the DB-25 end of the connector to the modem, configured as described above.

7. Connect the modem to the POTS line as required by the manufacturer.

8. Login to the ATLAS system. (Refer to DLP-2, System Login and Menu Access, on page 319 for

detailed instructions.)

9. From the M

AIN MENU, select the SYSTEM CONFIG menu and press the right arrow key to enter the

right-pane menus.

10. From the S

YSTEM CONFIG menu, select the ADMIN PORT menu and press <Enter>. Once in the ADMIN

ORT menus, press the right arrow key to enter the right-pane menus.

The unit may be left in direct mode with DTR set to IGNORE; however, automatic disconnect

on logoff and authentication failure will be lost.

The ADMIN port may be configured via Telnet or the CRAFT port.