Instruction manual

DLP-9 Connecting the ATLAS to an External Modem

Introduction

The ATLAS can be accessed and managed via a modem, allowing the same capabilities to the user as if

connected to the local A

DMIN port.

ATLAS 830

Access is provided by a female DB-9 connector, labeled ADMIN, located on the back of the unit .

ATLAS 890

Access is provided by an RJ-45 ADMIN port on the System Controller card.

Prerequisite Procedures

The ATLAS should be mounted in its permanent location before connecting to an external modem.

Tools and Materials Required

•Modem

• Null Modem, Full Handshake Cable

• Female RJ-45 to Male DB-25 Connector (shipped with ATLAS 890 unit)

Instructions for Connecting to an External Modem

1. Mount the modem in its permanent position.

2. Connect power to the modem using manufacturer instructions.

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

Electronic modules can be damaged by static electrical discharge. Before handling modules,

wear an antistatic discharge wrist strap to prevent damage to electronic components. Place

modules in antistatic packing material when transporting or storing. When working on

modules, always place them on an approved antistatic mat that is electrically grounded.