Instruction manual

DLP-8 Saving the Current Configuration using TFTP

Introduction

The ATLAS supports configuration transfers from the unit (via the 10/100 BASET Ethernet port) to a TFTP

server located on the network. This DLP provides the steps to follow for a successful configuration transfer

using the

10/100 BASET Ethernet port and a TFTP Server.

Tools and Materials Required

• A PC with a Telnet client software

• A TFTP Server accessible on the local network (A TFTP server is provided with the unit as part of the

ADTRAN Utilities software.)

TFTP Instruction for Saving a Configuration

1. Connect to the ATLAS using the 10/100 BASET interface. (Telnet to the unit.)

2. Login to the unit using the read-write password (see DLP-2, System Login and Menu Access, on page 319

for details).

3. Go to the S

YSTEM UTILITY menu and select the CONFIGURATION TRANSFER menu; press <Enter>.

4. Set the TFTP S

ERVER IP ADDRESS to the IP address of the machine running the TFTP Server

Program.

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

Electronic modules can be damaged by static electrical discharge. Before handling modules,

wear an antistatic discharge wrist strap to prevent damage to electronic components. Place

modules in antistatic packing material when transporting or storing. When working on

modules, always place them on an approved antistatic mat that is electrically grounded.

The procedures in DLP-1 through DLP-4 must be completed prior to the Telnet login.