Instruction manual

DLP-4 Verifying Communications Over an IP LAN

Introduction

This procedure outlines the steps for testing the ATLAS, when its Ethernet port is connected to a local area

network (LAN). Testing ensures that the unit is communicating properly over the network.

Prerequisite Procedures

Before beginning this procedure, the unit should be physically connected to the LAN and all provisioning

tasks should be complete (see DLP-3,

Setting IP Parameters for the ATLAS 800 Series System, on page 322).

Tools and Materials Required

Access to a PC or other computer connected to the LAN

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

Electronic modules can be damaged by static electrical discharge. Before handling

modules, wear an antistatic discharge wrist strap to prevent damage to electronic

components. Place modules in antistatic packing material when transporting or storing.

When working on modules, always place them on an approved antistatic mat that is

electrically grounded.