Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

311

312

313

314

315

316

317

318

319

320

ATLAS 800 Series System Manual Dial Plan

Pkt Voice: User Term - Ifce Config

Source ID Simplifies the creation of a dial plan in applications where the criterion for

switching calls to a certain endpoint is a function of which endpoint originated

the call.

•

DEFAULT VALUE = 0. Zero is the default ID for all endpoints and accept

numbers. With default values, all calls are routed based only on the dialed

number.

• Multiple endpoints can have the same

SOURCE ID.

• When creating the

CALL ACCEPT list, specify a SOURCE ID(s) as well as a

dialed number or range of dialed numbers to accept.

Pkt Voice: User Term - Ifce Config

Write security: 3; Read security: 5

This menu allows the user to define option parameters for ports configured as user packet voice endpoints.

Specifies the configuration parameters for the endpoint.

DLCI Selects the appropriate DLCI for this dial plan entry.

Voice Port Identifies the voice port address of the remote unit. FSU 5622s support ports 1

and 2. A remote ATLAS supports ports 1 through 255.

Conflict Report Describes existing conflicts. Potential problems include DLCI unavailable or

Voice port already in use.

Voice Compression Selects the voice compression algorithm used by this endpoint. ADTRAN FSU

5622 and Express 5200 Series FRADs use CCITT

G.723.1 compression at 6.3

kbps. The Express 5200 Series FRADs also support the proprietary

NETCODER

Algorithm at 6.4 kbps. Both endpoints must agree about the compression

algorithm choice.

Silence Suppression Reduces the total system bandwidth load by preventing ATLAS from sending

frames containing a special silence code during periods of silence. Both

endpoints must agree to use silence suppression. By default, silence suppression

DISABLED. To prohibit silence frames from transmitting and to decrease the

total system bandwidth,

ENABLE this feature.

Signaling Method Selects the type of signaling that the remote port is configured to expect.

Available options include the following:

E&M IMMEDIATE, E&M WINK, and LOOP

TART.