Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 309
ATLAS 800 Series System Manual Dial Plan
Pkt Endpt: User Term - Ifce Config
Route Incoming Call Use the three submenus to define a method for associating incoming calls to the
packet endpoints.
Support DBU
Handshake This option is only available when the packet endpoint selected in the
PORT/PEP field has backup sublinks. SUPPORT DBU HANDSHAKE
enables/disables the generation and acceptance of ADTRAN frame relay
handshake upon connection. If the endpoint is configured to route incoming
calls based on the handshake information, this option is automatically enabled.
If another call routing method is in effect, however, this option can be enabled
to support the use of handshake information at the far end of the link.
The
SUPPORT DBU HANDSHAKE submenu, DLCI TRANSLATION, controls contents
of the ADTRAN frame-relay handshake upon connection of a backup PVC.
Normally this field should be set to
AUTO. The FORCED mode is present for
compatibility with older IQ units.
Min DS0’s Set this to 1 for typical single-call connections. A value greater than 1 will
restrict connections to endpoints supporting aggregation (e.g., BONDING) of
the specified number of DS0s.
Max DS0’s Set this to 1 for typical single-call connections. A value greater than 1 will
accommodate connections to endpoints supporting aggregation (e.g.,
BONDING) of up to the specified number of DS0s. This also sets the number of
DS0s presented in the negotiation of outgoing aggregate calls.
Call Routing Table This table is only visible if GROUP is selected in the PRT/PEP field. The table
format changes, based on the selected routing option. For each case,
CALL
P
ARAMS contain OUTDIAL#, CALLER ID, SOURCE ID, and MIN/MAX DS0S, as
described above.
Submenu Descriptions
Using Incoming Num
Endpoint selection based on the incoming number.
Using Calling
Party Num
Selection based on the Caller ID as presented by the calling party. If this option
is selected, the
CALL PARTY NUMBER field is made available to the interface
configuration. This number allows you to configure the calling part number
used to select this packet endpoint.
Using DBU
Handshake
Selection based on a proprietary protocol. This option is only available to packet
endpoints with backup sublinks.
DBU HANDSHAKE is required to interoperate
with ADTRAN IQ and Express family products. It enables the association of
incoming calls with packet endpoints in cases where there is a single call-in
number (hunt group) and no Caller ID information available.
DBU HANDSHAKE must be disabled for DBU between two ATLAS products.