Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 307
ATLAS 800 Series System Manual Dial Plan
Async232: User Term - Ifce Config
Async232: User Term - Ifce Config
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports configured for Async-232 connections.
Specifies the configuration parameters for the endpoint.
Ports Available Indicates which ports of the selected Async-232 Option Module have been
defined in this switched endpoint (indicated by “!”) or in another switched
endpoint (indicated by “s”). This field is read-only. The following characters
may display in this field:
Number of Ports Specifies the number of Async-232 ports ATLAS 800 Series uses for this
endpoint.
Source ID Simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call.
•
DEFAULT VALUE = 0. Zero is the default ID for all endpoints and all accept
numbers. With default values, all calls are routed based only on the dialed
number.
• Multiple endpoints can have the same
SOURCE ID.
• When creating the
CALL ACCEPT list, specify a SOURCE ID(s) as well as a
dialed number or range of dialed numbers to accept.
For example, an application requires that all calls that originate from Port 1 of
the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.
Assign a unique
SOURCE ID (e.g., 7) to Port 1 of the module, and then configure
Port 2 to only accept calls from that unique
SOURCE ID (7).
Busy Out Number of milliseconds that passes before this Async-232 endpoint is set to
permanently busy and will no longer be available for use.
Idle Time Number of seconds that passes before this Async-232 endpoint is set to idle
status.
Character Description
0-9
This port is available. The digit that displays in this field
represents the last digit of the port number.
*
This port is requesting this port for this connection, but the port is
not yet activated.
!
This port is used by this endpoint.
s
This port is used elsewhere in the switched dial plan.
S
This port is in the switched dial plan and conflicts with this
endpoint.