Instruction manual

ATLAS 800 Series System Manual Dial Plan

Octal BRI S/T: User Termination

The Octal BRI S/T Module acts like the network while interfacing to user equipment (terminal adapters).

When you are working in the network termination section of the

DIAL PLAN menu and SLT is defined as a

S/T BRI module, the following interface configuration options are available:

Switch Type Write security: 2; Read security: 5

Defines the type of ISDN switch that the port will simulate. If connected to

another ATLAS, both need to be set to the same type. The following options are

available:

LUCENT 5E, NORTHERN DMS 100, NATIONAL-ISDN, and EURO-ISDN.

SPID List Write security: 2; Read security: 5

The port, acting as the network, must use a SPID and a phone number in order

to satisfy the ISDN connection protocol expected by the user’s Terminal

Adapter (TA).

To use the Octal BRI S/T Module on a User Term endpoint, use of a straight-through ISDN S/T

cable.

Submenu Descriptions

Phone Number

The phone number(s) assigned to this BRI phone line.

SPID Number

Defines the SPID number(s) used for this BRI line. Although the value of the

SPID is not significant, a SPID must be entered for each phone number. For

convenience, the SPID can be set to be the same as the phone number. Octal

BRI S/T Module does not support autoSPID detection software which some

terminal adapters offer.

No SPID Number is needed for the Euro-ISDN Switch Type.

Calls

For User terminations, the number of calls is fixed at 2.

D64, D56, Audio,

Speech

These options reflect what the network has provisioned for this SPID. If the BRI

was purchased with different services provisioned for the SPIDs, then the call

must match the services supported.