Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

301

302

303

304

305

306

307

308

309

310

ATLAS 800 Series System Manual Dial Plan

Octal BRI/U: User Term - Ifce Config

Source ID Simplifies the creation of a dial plan in applications where the criterion for

switching calls to a certain endpoint is a function of which endpoint originated

the call.

•

DEFAULT VALUE = 0. Zero is the default ID for all endpoints and all accept

numbers. With default values, all calls are routed based only on the dialed

number.

• Multiple endpoints can have the same

SOURCE ID.

• When creating the

CALL ACCEPT list, specify a SOURCE ID(s) as well as a

dialed number or range of dialed numbers to accept.

For example, an application requires that all calls that originate from Port 1 of

the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.

Assign a unique

SOURCE ID (e.g., 7) to Port 1 of the module, and then configure

Port 2 to only accept calls from that unique

SOURCE ID (7).

Swap ANI/DNIS Swaps the ANI and DNIS numbers received from the network. ANI (Automatic

Number Identification) is the billing number of the calling party, and DNIS

(Dialed Number Identification Service) is the called party number.

Octal BRI/U: User Term - Ifce Config

Write security: 3; Read security: 5

This menu allows the user to define option parameters for ports which emulate a BRI connection. Specifies

the configuration parameters for the endpoint.

Switch Type Defines the type of BRI switch the ATLAS 800 Series emulates. If connected to

another ATLAS 800 Series, both need to be set to the same switch type. The

following options are available:

LUCENT 5E, NORTHERN DMS 100, and

NATIONAL ISDN.

SPID List The port, acting as the network, must use a Service Profile Identifier (SPID) and

phone number(s) in order to satisfy the ISDN connection protocol expected by

the user’s terminal adapter (TA).

Submenu Descriptions

Phone Number

The phone number(s) assigned to this BRI phone line.

SPID Number

Defines the SPID number(s) used for this BRI line. Although the value of the

SPID is not significant, a SPID must be entered for each phone number. For

convenience, the SPID can be set to be identical to the phone number.

The ATLAS 800 Series does not support autoSPID detection software which some

terminal adapters offer.

Calls

For user termination, the number of calls which can be received or sent on this

number/SPID is fixed at 2.