Instruction manual

ATLAS 800 Series System Manual Dial Plan

Octal BRI/U: Network Term - Ifce Config

SPID List To properly operate with a network ISDN switch, the BRI interface must have

Service Profile Identifiers (SPIDs) and phone number(s) that match the SPID(s)

and phone number(s) programmed into the ISDN switch for this line. Each BRI

may have one or more phone numbers and SPIDs. The

SPID LIST submenus

define these parameters to the ATLAS 800 Series.

Strip MSD Strips a selected quantity (choose from NONE, 1, 2, and 3) of the most

significant digits (MSD) of a dialed number prior to being forwarded out of the

port.

Example: A network port could be set to accept all calls beginning with 9 (9$),

and then with

STRIP MSD set to 1, all digits would be sent toward the network

except the leading 9.

STRIP MSD does not affect CALL ACCEPT criteria. All of the digits (including the

MSDs that are subsequently stripped) are used as accept criterion.

Submenu Descriptions

Phone Number

The phone number(s) assigned to this BRI phone line.

SPID Number

This entry must match the SPID number(s) which has been set in the network’s

ISDN switch (or in the PBX) for this BRI line. A SPID must be entered for each

phone number.

Calls

The number of calls (1 or 2) which can be received or sent on this

number/SPID.

D64, D56, Audio,

Speech

These options reflect the network provisions for this SPID. If the BRI was

purchased with different services provisioned for the SPIDs, then the call must

match the services supported.