Instruction manual

ATLAS 800 Series System Manual Dial Plan

Octal BRI/U: Network Term - Ifce Config

Source ID Simplifies the creation of a dial plan in applications where the criterion for

switching calls to a certain endpoint is a function of which endpoint originated

the call.

•

DEFAULT VALUE = 0. Zero is the default ID for all endpoints and all accept

numbers. With default values, all calls are routed based only on the dialed

number.

• Multiple endpoints can have the same

SOURCE ID.

• When creating the

CALL ACCEPT list, specify a SOURCE ID(s) as well as a

dialed number or range of dialed numbers to accept.

For example, an application requires that all calls that originate from Port 1 of

the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.

Assign a unique

SOURCE ID (e.g., 7) to Port 1 of the module, and then configure

Port 2 to only accept calls from that unique

SOURCE ID (7).

Min DS0’s Set this to 1 for typical single-call connections. Setting this greater than 1 will

restrict connections to endpoints supporting aggregation (e.g., BONDING) of

the specified number of DS0s.

Max DS0’s Set this to 1 for typical single-call connections. Setting this greater than 1 will

accommodate connections to endpoints supporting aggregation (e.g.,

BONDING) of up to the specified number of DS0s. This also sets the number of

DS0s presented in the negotiation of outgoing aggregate calls.

Octal BRI/U: Network Term - Ifce Config

Write security: 3; Read security: 5

This menu allows the user to define option parameters for ports which terminate a BRI connection from the

network. Specifies the configuration parameters for the endpoint.

Switch Type Defines the type of BRI switch to which the port is connected. If connected to

another ATLAS 800 Series, both need to be set to the same switch type. The

following options are available:

LUCENT 5E, NORTHERN DMS 100, and

NATIONAL ISDN.