Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

291

292

293

294

295

296

297

298

299

300

ATLAS 800 Series System Manual Dial Plan

E1/PRA: User Term - Ifce Config (PRA)

B Channel Selection Determines how the ATLAS 800 Series switchboard uses B channels for call

routing. The Circular method can be used for call load balancing among the

available B channels on this interface.

E1/PRA: User Term - Ifce Config (PRA)

Write security: 3; Read security: 5

his menu allows the user to define option parameters for ports which emulate a PRA connection.

Specifies the configuration parameters for the endpoint.

Switch Type Defines the type of PRA switch that the ATLAS 800 Series emulates. If

connected to another ATLAS 800 Series, both need to be set to the same switch

type. The following option is available:

ETSI/DSS1.

First DS0 Defines the first DS0 for this endpoint.The ATLAS 800 Series uses DS0s,

starting with this selection, to send and receive calls to and from the network.

The outgoing calls which are allowed or restricted over these DS0s are set by

OUT#ACCEPT (see Out#Accept on page 268) and OUT#REJECT (see Submenus on

page 274).

Number of DS0s Specifies the number of DS0s ATLAS 800 Series uses for this endpoint.

Strip MSD Strips a selected quantity (choose from NONE, 1, 2, and 3) of the most

significant digits (MSD) of a dialed number prior to being forwarded out of the

port. For example, a network port could be set to accept all calls beginning with

9 (9$), and then with

STRIP MSD set to 1, all digits would be sent toward the

network except the leading 9.

STRIP MSD does not affect CALL ACCEPT criteria. All of the digits (including the

MSDs that are subsequently stripped) are used as accept criterion.

Network Specific Facility

Voice and Data Enables the sending of appropriate information to the PSTN. Currently not

supported for E1/PRA use.

Called Digits TransferredDefines the number of digits to forward from the called number. When attached

to a PBX, the PBX may be provisioned to expect to receive fewer than all of the

called digits of the incoming call; however, this option would normally be set to

ALL. Choose from NONE, THREE, FOUR, SEVEN, or ALL.

Submenu Descriptions

Normal

Always start with the last channel configured (i.e., for a full PRI channel 23

would be used if available).

Circular

Contiguous channels from last to first.