Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 295
ATLAS 800 Series System Manual Dial Plan
E1/PRA: Network Term - Ifce Config (PRA)
Network Specific Facility
Voice and Data Enables the sending of appropriate information to the PSTN. Currently not
supported for E1/PRA use.
Called Digits
Transferred Some PRI switches may be provisioned to send only a portion of the called
number (like DID). This menu item allows the ATLAS 800 Series to know how
many digits to expect (choose from
NONE, THREE, FOUR, SEVEN, and ALL). The
default is
ALL and would almost always be correct. If less than ALL digits are
sent, then the
PREFIX is defined as follows:
PREFIX displays only if CALLED DIGITS TRANSFERRED is not set to ALL. Enter the
prefix for the digits received. For example, if the number of digits is four and
the number called is 963-8615, the telco’s PRI switch sends only 8615 and the
prefix is set to 963. This entire number is then used to determine which
ATLAS 800 Series user port endpoint should receive the call.
Outgoing Caller ID Defines the number to use to provide Caller ID to the network for outgoing calls
sent through this endpoint. Choose from
SEND AS PROVIDED, SUBSTITUTE IF NOT
PRESENT, or SUBSTITUTE ALWAYS.
The Caller ID number must be specific (i.e., no wildcards).
Source ID Simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call.
•
DEFAULT VALUE = 0. Zero is the default ID for all endpoints and all accept
numbers. With default values, all calls are routed based only on the dialed
number.
• Multiple endpoints can have the same
SOURCE ID.
• When creating the
CALL ACCEPT list, specify a SOURCE ID(s) as well as a
dialed number or range of dialed numbers to accept.
For example, an application requires that all calls that originate from Port 1 of
the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.
Assign a unique
SOURCE ID (e.g., 7) to Port 1 of the module, and then configure
Port 2 to only accept calls from that unique
SOURCE ID (7).
Swap ANI/DNIS Swaps the ANI and DNIS numbers received from the network. ANI (Automatic
Number Identification) is the billing number of the calling party, and DNIS
(Dialed Number Identification Service) is the called party number.
With this swap, the ATLAS 800 Series switchboard uses ANI to route the call. The
accept number in the dial plan must use the ANI number, not the DNIS number.