Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

291

292

293

294

295

296

297

298

299

300

ATLAS 800 Series System Manual Dial Plan

E1/PRA: Network Term - Ifce Config (PRA)

B Channel Selection The following B CHANNEL SELECTION submenus determine how the ATLAS 800

Series switchboard uses B channels for call routing. The Circular method can be

used for call load balancing among the available B channels on this interface.

Busy Option The following BUSY OPTION submenus define the response propagated to the

CPE upon receipt of a

DISCONNECT USER-BUSY message from the network.

E1/PRA: Network Term - Ifce Config (PRA)

Write security: 3; Read security: 5

This menu allows the user to define option parameters for ports which terminate a PRA connection from

the network. Specifies the configuration parameters for the endpoint.

Switch Type Defines the type of PRA switch to which the port is connected. If connected to

another ATLAS 800 Series, both need to be set to the same switch type. The

following option is available:

ETSI/DSS1.

First DS0 Defines the first DS0 for this endpoint.The ATLAS 800 Series uses DS0s,

starting with this selection, to send and receive calls to and from the network

(PSTN). The outgoing calls which are allowed or restricted over these DS0s are

set by

OUT#ACCEPT (see Out#Accept on page 268) and OUT#REJECT (see

Submenus on page 274).

Number of DS0s Specifies the number of DS0s ATLAS 800 Series uses for this endpoint.

Strip MSD Strips a selected quantity (choose from NONE, 1, 2, and 3) of the most

significant digits (MSD) of a dialed number prior to being forwarded out of the

port.

Example: A network port could be set to accept all calls beginning with 9 (9$),

and then with

STRIP MSD set to 1, all digits would be sent toward the network

except the leading 9.

STRIP MSD does not affect CALL ACCEPT criteria. All of the digits (including the

MSDs that are subsequently stripped) are used as accept criterion.

Submenu Descriptions

Normal

Always start with the last channel configured (i.e., for a full PRI channel 23

would be used if available).

Circular

Contiguous channels from last to first.

Submenu Descriptions

Normal

Send a Progress message to the CPE and map busy tones.

Pass-Thru

Send a DISCONNECT USER-BUSY message to the User Term CPE device.