Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

291

292

293

294

295

296

297

298

299

300

ATLAS 800 Series System Manual Dial Plan

T3 and T3 D&I: User Term - Ifce Config (NFAS)

• Nortel InWats

• AT&T SDN

• Nortel Foreign Exchange

• National ISDN INWATS

• Nortel OutWats

• Nortel Private Network

• Nortel Tie Trunk

Called Digits TransferredSome PRI switches may be provisioned to send only a portion of the called

number (like DID). This menu item allows the ATLAS 800 Series to know how

many digits to expect (choose from

NONE, THREE, FOUR, SEVEN, and ALL). The

default is

ALL and would almost always be correct. If less than ALL digits are

sent, then the

PREFIX is defined as follows.

Outgoing Caller ID Defines the number for the ATLAS 800 Series to use to provide Caller ID to the

network for outgoing calls sent through this endpoint. Choose from

SEND AS

PROVIDED, SUBSTITUTE IF NOT PRESENT, or SUBSTITUTE ALWAYS.

The Caller ID number must be specific (i.e., no wildcards).

Source ID Simplifies the creation of a dial plan in applications where the criterion for

switching calls to a certain endpoint is a function of which endpoint originated

the call.

•

DEFAULT VALUE = 0. Zero is the default ID for all endpoints and all accept

numbers. With default values, all calls are routed based only on the dialed

number.

• Multiple endpoints can have the same

SOURCE ID.

• When creating the

CALL ACCEPT list, specify a SOURCE ID(s) as well as a

dialed number or range of dialed numbers to accept.

For example, an application requires that all calls that originate from Port 1 of

the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.

Assign a unique

SOURCE ID (e.g., 7) to Port 1 of the module, and then configure

Port 2 to only accept calls from that unique

SOURCE ID (7).

Swap ANI/DNIS Swaps the ANI and DNIS numbers received from the network. ANI (Automatic

Number Identification) is the billing number of the calling party, and DNIS

(Dialed Number Identification Service) is the called party number.

With this swap, the ATLAS 800 Series switchboard uses ANI to route the call. The

accept number in the dial plan must use the ANI number, not the DNIS number.