Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

291

292

293

294

295

296

297

298

299

300

ATLAS 800 Series System Manual Dial Plan

T3 and T3 D&I: User Term - Ifce Config (NFAS)

Switch Type Defines the type of PRI switch to which the port is connected. If connected to

another ATLAS 800 Series, both need to be set to the same switch type. The

following options are available:

AT&T 4ESS, LUCENT 5E, NORTHERN DMS 100,

and

NATIONAL ISDN.

First DS0 Defines to the ATLAS 800 Series the first DS0 for this endpoint. The

ATLAS 800 Series uses DS0s, starting with this selection, to send and receive

calls to and from the network. The outgoing calls which are allowed or

restricted over these DS0s are set by

OUT#ACCEPT (see Out#Accept on page 268)

and

OUT#REJECT (see Submenus on page 274).

Number of DS0s Specifies the number of DS0s ATLAS 800 Series uses for this endpoint.

Strip MSD Strips a selected quantity (choose from NONE, 1, 2, and 3) of the most

significant digits (MSD) of a dialed number prior to being forwarded out of the

port.

Example: A network port could be set to accept all calls beginning with 9 (9$),

and then with

STRIP MSD set to 1, all digits would be sent toward the network

except the leading 9.

STRIP MSD does not affect CALL ACCEPT criteria. All of the digits (including the

MSDs that are subsequently stripped) are used as accept criterion.

Network Specific Facility

Voice and Data Enables the sending of appropriate information to the PSTN. The default for this

option is

NORMAL, and in this case no Network Specific Facility Information

Element is sent. Unless one of the services listed below is subscribed to, the

selection should remain set to

NORMAL.

The list below indicates services that may be subscribed to from the PSTN.

These services require that specific information (such as a Network Specific

Facility Information Element) be sent to the network during call setup.

• AT&T Accunet

• AT&T Dial-It 900/Multiquest

• AT&T International-800

• AT&T Long Distance

• AT&T Megacom 800

• AT&T Megacom

Port

Configures the port that the interface is physically connected to.

Interface Number

Configures the NFAS Interface ID associated with the interface. The configure

ID must match the ID configured by the provider.

Backup D Channel

Backup D channel is not supported on User Term NFAS interfaces.

Only one backup D channel can be configured per NFAS interface group.

Submenu Description (Continued)