Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

291

292

293

294

295

296

297

298

299

300

ATLAS 800 Series System Manual Dial Plan

T3 and T3 D&I: User Term - Ifce Config (NFAS)

number.

• Multiple endpoints can have the same

SOURCE ID.

• When creating the

CALL ACCEPT list, specify a SOURCE ID(s) as well as a

dialed number or range of dialed numbers to accept.

For example, an application requires that all calls that originate from Port 1 of

the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.

Assign a unique

SOURCE ID (e.g., 7) to Port 1 of the module, and then configure

Port 2 to only accept calls from that unique

SOURCE ID (7).

Dial on OffHook Defines a number that is automatically sent to the switchboard when a call on

this endpoint is initiated (goes off hook).

The DIAL ON OFFHOOK number must be specific (i.e., no wildcards).

DS0 Alignment DS0 ALIGNMENT is typically enabled when a user needs the ability to maintain

alignment between T1s as if they were in dedicated map mode. This scenario

requires

DS0 ALIGNMENT enabled on both interfaces (usually on User Term and

on Net Term). An interface that has

DS0 ALIGNMENT enabled will only process a

call from the switchboard on the same DS0 that the incoming call was received.

For example, the unit receives an incoming call on DS0 17. The switchboard

looks for an interface who has matching accept criteria to the number it

received. A match is found on interface “Z” that has

DS0 ALIGNMENT enabled.

This causes interface “Z” to only process the call if it has DS0 17 available. If

all matching interfaces have

DS0 ALIGNMENT enabled and none of those

interfaces have DS0 17 available, then a busy or fast busy will be returned to the

calling party.

T3 and T3 D&I: User Term - Ifce Config (NFAS)

Write security: 3; Read security: 5

This menu allows the user to define option parameters for ports which emulate an NFAS connection.

Specifies the configuration parameters for the endpoint.

Secondary Interfaces The following SECONDARY INTERFACES submenus allow the user to define the

slot and port locations of the secondary interfaces in the NFAS group.

Submenu Description

Displays the entry number.

Slot

Configures the slot that the interface is physically connected to.