Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

281

282

283

284

285

286

287

288

289

290

ATLAS 800 Series System Manual Dial Plan

T3 and T3 D&I: Network Term - Ifce Config (NFAS)

For example, the unit receives an incoming call on DS0 17. The switchboard

looks for an interface who has matching accept criteria to the number it

received. A match is found on interface “Z” that has

DS0 ALIGNMENT enabled.

This causes interface “Z” to only process the call if it has DS0 17 available. If

all matching interfaces have

DS0 ALIGNMENT enabled and none of those

interfaces have DS0 17 available, then a busy or fast busy will be returned to the

calling party.

T3 and T3 D&I: Network Term - Ifce Config (NFAS)

Write security: 3; Read security: 5

This menu allows the user to define option parameters for ports which terminate a PRI connection from the

network. Specifies the configuration parameters for the endpoint.

Secondary Interfaces The following SECONDARY INTERFACES submenus allow the user to define the

slot and port locations of the secondary interfaces in the NFAS group.

Switch Type Defines the type of PRI switch to which the port is connected. If connected to

another ATLAS 800 Series, both need to be set to the same switch type. The

following options are available:

LUCENT 5E, NORTHERN DMS 100, NATIONAL

ISDN

, and AT&T 4ESS.

First DS0 Defines the first DS0 for this endpoint.The ATLAS 800 Series uses DS0s,

starting with this selection, to send and receive calls to and from the network.

The outgoing calls which are allowed or restricted over these DS0s are set by

OUT#ACCEPT (see Out#Accept on page 268) and OUT#REJECT (see Submenus on

page 274).

Number of DS0s Specifies the number of DS0s ATLAS 800 Series uses for this endpoint.

submenu Descriptions

Displays the entry number.

Slot

Configures the slot that the interface is physically connected to.

Port

Configures the port that the interface is physically connected to.

Interface Number

Configures the NFAS Interface ID associated with the interface. The configure

ID must match the ID configured by the provider.

Backup D Channel

Disables or enables backup D channel on the interface.

Only one backup D channel is supported in a single chassis.