Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 281
ATLAS 800 Series System Manual Dial Plan
T3 and T3 D&I: Network Term- Ifce Config (RBS)
DS0s Available Indicates which DS0s of the T1 have been defined in this switched endpoint
(indicated by “! “), in another switched endpoint (indicated by “s”), or in a
DEDICATED MAP (indicated by “n”). This field is read-only. The following
characters may display in this field:
Signaling Method Defines to the ATLAS 800 Series the type of signaling to be used across this
trunk. The signaling selected needs to match the signaling being provided by the
network (PSTN). The following choices are available:
E&M IMMEDIATE, E&M
W
INK, LOOP START, GROUND START, and FEATURE GROUP D.
The ATLAS 800 Series converts signaling types between network and user terminations.
FGD Tx Sequence Displayed only if SIGNALING METHOD is configured for FEATURE GROUP D.
Defines to the ATLAS 800 Series the format in which to present the outgoing
digits. Choices:
NORMAL if no digits are to be sent; ANI/DNIS to send both ANI
and DNIS;
DNIS to send DNIS only; ANI to send ANI only.
FGD Rx Sequence Displayed only if SIGNALING METHOD is configured for FEATURE GROUP D.
Defines to the ATLAS 800 Series the format in which to receive the incoming
digits. Choices:
NORMAL if no digits are to be received; ANI/DNIS to receive
both ANI and DNIS;
DNIS to receive DNIS only; ANI to receive ANI only.
Wink after ANI/DNIS Displayed only if SIGNALING METHOD is configured for FEATURE GROUP D.
When enabled, the ATLAS 800 Series will transmit a wink after ANI/DNIS
digits are transmitted.
Digit Suppression When enabled, no digits will be sent toward the network/PBX after going
off-hook on an outgoing call.
Direct Inward Dialing Defines to the ATLAS 800 Series whether Direct Inward Dialing (DID) is being
used by the network. If
DID is ENABLED, then the following information must be
defined.
Characters Description
0-9
This DS0 is available. The digit that displays in this field
represents the last digit of the DS0 number.
*
This port is requesting this DS0 for this connection, but the DS0
is not yet activated.
!
This DS0 is used by this endpoint.
s
This DS0 is used elsewhere in the switched DIAL PLAN.
S
This DS0 is in the switched dial plan and conflicts with this
endpoint.
n
This DS0 is used in one or more DEDICATED MAPS.
N
This DS0 is in one or more DEDICATED MAPS, and conflicts with
this endpoint.