Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 280
ATLAS 800 Series System Manual Dial Plan
T3 and T3 D&I: Network Term- Ifce Config (RBS)
For example, an application requires that all calls that originate from Port 1 of
the ATLAS 800 Series in Slot 1 be switched to Port 2 of that same module.
Assign a unique
SOURCE ID (e.g., 7) to Port 1 of the module, and then configure
Port 2 to only accept calls from that unique
SOURCE ID (7).
Swap ANI/DNIS Swaps the ANI and DNIS numbers received from the network. ANI (Automatic
Number Identification) is the billing number of the calling party, and DNIS
(Dialed Number Identification Service) is the called party number.
With this swap, the ATLAS 800 Series switchboard uses ANI to route the call. The
accept number in the dial plan must use the ANI number, not the DNIS number.
B Channel Selection
The following B Channel Selection submenus determine how the ATLAS 800
Series switchboard uses B channels for call routing. The Circular method can be
used for call load balancing among the available B channels on this interface.
Busy Option Defines the response propagated to the CPE upon receipt of a DISCONNECT
U
SER-BUSY message from the network.
T3 and T3 D&I: Network Term- Ifce Config (RBS)
Write security: 3; Read security: 5
These menus allow the user to define option parameters for ports which terminate an RBS T1 connection
from the network. Specifies the configuration parameters for the endpoint.
First DS0 Defines to the ATLAS 800 Series the first DS0 for this endpoint.The
ATLAS 800 Series uses DS0s, starting with this selection, to send and receive
calls to and from the network. The outgoing calls which are allowed or
restricted over these DS0s are set by
OUT#ACCEPT (see Out#Accept on page 268)
and
OUT#REJECT (see Submenus on page 274).
Number of DS0s Specifies the number of DS0s ATLAS 800 Series uses for this endpoint.
Submenu Description
Circular
Contiguous channels from last to first.
Normal
Always start with the last channel configured (i.e., for a full PRI channel 23
would be used if available).
Submenu Description
Normal
Send a progress message to the CPE and map busy tones.
Pass-Thru
Send a DISCONNECT USER-BUSY message to the User Term CPE device.