Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 279
ATLAS 800 Series System Manual Dial Plan
T3 and T3 D&I: Network Term - Ifce Config (PRI)
may be subscribed to from the PSTN. These services require that specific
information (such as a Network Specific Facility Information Element) be sent
to the network during call setup.
• AT&T SDN (Switched Digital Network)
• National ISDN INWATS
• AT&T Megacom 800
• Nortel Private Network
• AT&T Megacom
• Nortel InWats
• AT&T Accunet
• Nortel OutWats
• AT&T Long Distance
• Nortel Foreign Exchange
• AT&T International-800
• Nortel Tie Trunk
• AT&T Dial-It 900/Multiquest
Called Digits
Transferred Some PRI switches may be provisioned to send only a portion of the called
number (like DID). This menu item allows the ATLAS 800 Series to know how
many digits to expect (choose from
NONE, THREE, FOUR, SEVEN, and ALL). The
default is
ALL and would almost always be correct. If less than ALL digits are
sent, then the
PREFIX is defined as follows:
Displays only if
CALLED DIGITS TRANSFERRED is not set to ALL. Enter the prefix
for the digits received. For example, if the number of digits is four and the
number called is 963-8615, the telco’s PRI switch sends only 8615 and the
prefix is set to 963. This entire number is then used to determine which
ATLAS 800 Series user port endpoint should receive the call.
Outgoing Caller ID Defines the number to use to provide Caller ID to the network for outgoing calls
sent through this endpoint. Choose from
SEND AS PROVIDED, SUBSTITUTE IF NOT
PRESENT, or SUBSTITUTE ALWAYS.
The Caller ID number must be specific (i.e., no wildcards).
Source ID Simplifies the creation of a dial plan in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint originated
the call.
•
DEFAULT VALUE = 0. Zero is the default ID for all endpoints and all accept
numbers. With default values, all calls are routed based only on the dialed
number.
• Multiple endpoints can have the same
SOURCE ID.
• When creating the CALL ACCEPT list, specify a SOURCE ID(s) as well as a
dialed number or range of dialed numbers to accept.