Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 277
ATLAS 800 Series System Manual Dial Plan
T3 and T3 D&I: Network Term - Ifce Config (PRI)
Automatic Routeback
Rejection Write security: 1; Read security: 5
When enabled,
AUTOMATIC ROUTEBACK REJECTION prevents calls entering
through network termination interfaces from being forwarded out another
network interface. Such an event could happen if an incoming call specifies a
number that has no endpoint configured to accept it and another network
interface has a call acceptance entry which could accept it (such as $). Without
automatic rejection, such a call would be forwarded back to the network. The
network would in turn resend the call to the unit until all incoming resources are
consumed.
Collision Response Write security: 0; Read security: 0
When forced, the
COLLISION RESPONSE will enable the ATLAS to perform
AUTOMATIC retransmission of SETUP messages when faced with a collision
situation. Forcing this response is not advised.
Global Tone Type Write security: 1; Read security: 5
Specifies the dialing digit tone encoding to be used throughout the entire
system.T he available options include
DTMF (dual-tone-multi frequency) and
MF (multi frequency).
T3 and T3 D&I: Network Term - Ifce Config (PRI)
Write security: 3; Read security: 5
These menus allow the user to define option parameters for ports which terminate a PRI connection from
the network. Specifies the configuration parameters for the endpoint.
Switch Type Defines the type of PRI switch to which the port is connected. If connected to
another ATLAS 800 Series, both need to be set to the same switch type. The
following options are available:
LUCENT 5E, NORTHERN DMS 100, NATIONAL
ISDN
, and AT&T 4ESS.
First DS0 Defines the first DS0 for this endpoint.The ATLAS 800 Series uses DS0s,
starting with this selection, to send and receive calls to and from the network.
The outgoing calls which are allowed or restricted over these DS0s are set by
OUT#ACCEPT (see Out#Accept on page 268) and OUT#REJECT (see Submenus on
page 274).
Number of DS0s Specifies the number of DS0s ATLAS 800 Series uses for this endpoint.
Use extreme caution when disabling AUTOMATIC ROUTEBACK REJECTION or
COLLISION RESPONSE.