Instruction manual

ATLAS 800 Series System Manual Dial Plan

Global Param

ATLAS 800 Series defaults cover almost any installation, and these templates

should not require any additional user input – except for unusual circumstances.

The template allows the use of the following wildcard inputs to define numbers:

Number Type Templates The following NUMBER TYPE TEMPLATES submenus set call-type patterns. ISDN

interfaces require that a number type be sent over the D channel when a call is

sent or received. A normal RBS trunk does not send a type designator, but uses

prefixes instead. For example, “1 +” prefix is a national long distance call type

while a “011 +” prefix is an international long distance call type. These

templates form a table to permit ATLAS 800 Series to translate the RBS prefix

into a call type for ISDN and vice-versa.

The ATLAS 800 Series default templates should cover all applications and should not

need to be added to by the user except for very rare circumstances.

X = Any single digit

N = Any single digit 2 through 9

911 = This specific number

[1,2,3...] = A single digit in this group

Submenus Description

Denotes an entry number. The maximum number of entries is 50. Press <I> to

insert a new entry and <D> to delete any entry.

Prefix

Sets the prefix for the number type. Only digits 0 and 1 are allowed (maximum

of six characters).

Pattern

Modifies an entry when you press <Enter> (maximum of 40 characters). A

pattern for a normal long distance call, for example, would be 1+(NXX) NXX -

XXXX. Note that the symbols ( ), +, -, and space are not required and are only

used to improve the readability of this example.

Number Type

Lists valid selections when you press <Enter>. Selections include LOCAL,

ATIONAL, INTERNATIONAL, PRIVATE, and UNKNOWN.