Instruction manual

ATLAS 800 Series System Manual Dedicated Maps

Create/Edit Maps: Connects Menu - Pkt Endpt

Write security: 3; Read security: 5

To assign a packet endpoint to a physical port, select the port in the FROM SLOT/PORT field and configure

the

TO SLOT/PORT as follows:

To Slot/Service Select PKT ENDPNT to activate a list of available packet endpoints in the TO

ORT field.

To Port/PEP Press <Enter > and select the appropriate packet endpoint to assign the endpoint

to a physical port.

To/From Config Specifies the configuration for the TO/FROM connection. The following

selections apply to the packet endpoint:

Create/Edit Menus: Connects Menu - Pkt Voice

Write security: 3; Read security: 5

To Slot/Service Select Pkt Voice to activate a list of available packet endpoints in the TO PORT

field.

To Port/PEP Press <Enter> and select the appropriate packet endpoint from the drop-down

list.

To/From Config Specifies the configuration for the TO/FROM connection. The following

selections apply to the

PKT VOICE connections:

Submenu Description

Transmit Idle Code

Configures the ATLAS 800 Series to send idle code on the packet endpoint with

marks or flags.

Receive Idle Code

Defines the idle code (either marks or flags) the ATLAS 800 Series should

expect on the selected packet endpoint.

Submenu Description

DLCI

Press <Enter> and select the appropriate DLCI from the drop-down list.

Voice Port

Identifies the voice port address of the remote unit. Express units support ports

1 and 2. A remote ATLAS supports ports 1 through 255.

Conflict Report

Describes existing conflicts. Potential problems include DLCI unavailable or

Voice port already in use.