Instruction manual

ManualsBrandsCompatible Systems ManualsComputer equipmentOctal V.35 - 10/100 RIOP

261

262

263

264

265

266

267

268

269

270

ATLAS 800 Series System Manual Dedicated Maps

Create/Edit Maps: FXS-8 Connects Menu - To/From Config

Answer Supervision Configures answer supervision for the appropriate voice port. Answer

supervision (when the far end answers the call) is indicated by using reverse

battery polarity. This is valid for an outbound call only. On an FXS interface

type we respond to LSAS (Line Side Answer Supervision) signaling on the T1.

Our response is to reverse battery polarity on (T-R). Telco must configure their

T1 for LSAS if this is not a point-to-point T1.

E&M Conversion Configures the selected voice port for E&M signaling conversion. By enabling

this option, other selections become available that are E&M trunk specific. This

option is sometimes referred to as TANDEM conversion. The following

submenu items become visible when

E&M CONVERSION is ENABLED:

Submenu Description

E&M Supervision

Configures the E&M trunk as either Immediate start or Wink start. This

configuration is for the Rx and Tx direction. When DNIS delay is set, this

option only configures the Rx direction.

Dial Tone

Configures the ATLAS 830 to generate Dial Tone out the selected FXS port in

response to the 2W going off hook (outgoing call). Generally, dial tone is

provided by the Class 5 switch delivering the T1, but in some instances, the

switch cannot provide dial tone.

Ringback

Configures the ATLAS 830 to generate ringback tone to the far end while the

selected FXS port is ringing. Generally, ringback is provided by the Class 5

switch delivering the T1, but in some instances, the switch cannot provide

ringback tones.

DNIS

DelayDefines the time we delay after transmitting a wink in response to the 2W

going off hook (after ringing) before we send off hook in the RBS signaling.

This field is only valid for E&M conversion. The timing is as follows:

DNIS Wink Timeout

When DNIS DELAY is ENABLED, a wink will be returned to the originating switch

after 5 seconds if the FXS does not detect an off hook. This option, when

DISABLED, allows the FXS port to ring without winking until the call is

answered.

Trunks can be taken out of service by telco if there is No wink. Use caution when

disabling this option.

Rx AB

Tx AB

DNIS Delay

Off Hook