Instruction manual

ATLAS 800 Series System Manual Dedicated Maps

Create/Edit Maps: DS3 and DS3 D&I Connects Menu - To/From Config

NT/LT Configures the BRI U interface to be network termination or line termination.

Create/Edit Maps: DS3 and DS3 D&I Connects Menu - To/From Config

Write security: 3; Read security: 5

The following selections apply to the T3 and the T3 with Drop and Insert modules, depending on the

application:

DS0 Selection Defines DS0s for a specific T1 in the T3 circuit. Use this field to define the

DS0s for this connection. You can enter the DS0s in several ways. For example,

to enter DS0s one through five, enter

1,5. For DS0s one and five, enter 1,5.

DS0 Available Indicates which DS0s of the T1 are assigned. DS0 assignment is based on the

following items:

Create/Edit Maps: NxT1 HSSI Connects Menu - To/From Config

Write Security: 3; Read Security: 5

The following selection applies to the NxT1 HSSI Option Module when connected to a port on a T1

Module. This is the only valid application for the NxT1 HSSI Option Module.

DS0 Selection Defines DS0s for the T1 port. Use this field to define the DS0s for this

connection.

Any entry in the DS0 selection field that is less than 24 DS0s is disregarded. The NxT1

HSSI Module requires the use of all 24 DS0s on a T1 for proper operation.

Item Description

Digit 0-9

This DS0 is available. The digit that displays in this field represents the last digit of the

DS0 number.

This DS0 has been requested for this connection, but the DS0 is not yet activated for this

port.

This DS0 is used by this port in this connection and is currently activated.

This DS0 is used in the switched DIAL PLAN.

This DS0 is used in the switched DIAL PLAN and conflicts with this connection.

This DS0 is already used in this DEDICATED MAP.

This DS0 is already used in this DEDICATED MAP and conflicts with this connection.