Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 257
ATLAS 800 Series System Manual Dedicated Maps
Create/Edit Maps: E1/PRA Connects Menu -To/From Config
T1 Trunk Conditioning
State Defines the final fault signaling state.
T1 Fault Signaling Displays the final fault signaling state of the AB bits. This field is read-only
unless
CUSTOM is chosen for the T1 TRUNK CONDITIONING SERVICE option.
T1 Trouble Code Value Displays the Hex value of the 2.5 second pre-alarm transmission.
:
Create/Edit Maps: E1/PRA Connects Menu -To/From Config
Write security: 3; Read security: 5
Specifies the configuration for the TO/FROM connection. The following selections may apply to the Quad
E1/PRA Option Module, depending on the application:
TS0 Selection Defines TS0s for an E1 port. Use this field to define the TS0s for this
connection. You can enter the TS0s in several ways. For example, to enter TS0s
one through five, enter
1-5. For TS0s one and five, enter 1,5.
TS0 Available Indicates which TS0s of the E1 are assigned. TS0 assignment is based on the
following items:
TS0 Rate Sets the TS0 rate to either 56 or 64 kbps. This field is only valid for E1 ports
mapped to a
PKT ENDPNT.
Submenu Description
Idle
Used for one-way trunks; that is, for outgoing or incoming calls only – not both.
Seized
Used for two-way trunks. Prevents connected equipment from attempting to use
a failed trunk for an outgoing call.
Item Description
Digit 0-9
This TS0 is available. The digit that displays in this field represents the last digit of the
TS0 number.
*
This TS0 has been requested for this connection, but the TS0 is not yet activated for this
port.
!
This TS0 is used by this port in this connection and is currently activated.
s
This TS0 is used in the switched DIAL PLAN.
S
This TS0 is used in the switched DIAL PLANand conflicts with this connection.
n
This TS0 is already used in this DEDICATED MAP.
N
This TS0 is already used in this DEDICATED MAP and conflicts with this connection.