Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 231
ATLAS 800 Series System Manual Packet Manager
Packet Endpnts
The following fields display if P
RIMARY (with BACKUP SUPPORT) or BACKUP is
enabled:
Backup Mode
Switch on Sublink Down
Switch on LMI Inactive
Switch on Backup Active
Backup Delay in Seconds
Restore Delay in Seconds.
Test Write security: 3; Read security: 5
Provides menus for controlling options and setting for packet endpoints.
Primary | Backup
Selection
(continued.
Primary Packet Endpt
Visible only if BACKUP is selected. Selects the PRIMARY PACKET
E
NDPT that contains the PRIMARY SUBLINK to be tied to this sublink.
Primary Sublink
Visible only if BACKUP is selected. Selects the PRIMARY SUBLINK to
be tied to this sublink.
Backup Mode
Provides the following switching options: AUTO, FORCED, and
DISABLED. AUTO provides normal operation; FORCED forces a switch
to backup; and
DISABLED disables backup switching.
Switch on Sublink Inactive
Provides switching options if the sublink goes down. Select Yes to
switch to backup if the primary sublink goes down, otherwise select
No.
Switch on LMI Down
Provides switching options for LMI signaling. Select Yes to switch
to backup if LMI signaling is inactive on the primary link, otherwise
select No.
Switch on Backup Active
Provides switching options if the backup sublink goes active. Select
Yes to switch to backup if the backup sublink goes active, otherwise
select No.
Backup Delay in Seconds
The amount of time within which any of the enabled switch criteria
must be met before service is switched to the backup circuit.
Restore Delay in Seconds
The amount of time within which the criteria for switching to
backup are reached before service is returned to the primary circuit.
Table 8. DLCI Configuration Parameters (Continued)
Submenu Description