Instruction manual

61200780L1-1C © 2004 ADTRAN, Inc. 212
ATLAS 800 Series System Manual Async-232 Option Module
Session Status
Session Status
Read security: 5
Shows the status of key DTE interface signals. An asterisk (*) indicates the presence of a signal and a
hyphen (-) indicates no signal present.
Prt Displays the port number.
Mode Indicates the session mode for the port. The following modes are available:
Call Dir Read security: 5
Displays the current call direction as
INCOMING or OUTGOING. If there is no
active call,
IDLE will display.
Rsc Read security: 5
This field indicates the slot and device number allocated for a call to or from
this port. If no call is active, it will indicate
NONE. The allocated resource will be
either an analog modem, or an ISDN digital call resource.
Last Disconnect Read security: 5
This field indicates the reason for the last call disconnect or dialout failure for
this port. If no call has been attempted for the given port, this field will indicate
NONE. This information is also available in the system log if Async-232 module
events are enabled.
Hangup Write security: 3; Read security: 5
Activator used to hangup the current active call on the port.
Submenu Description
Unassigned
Port not assigned to a phone number in the Dial Plan.
Idle
Port assigned but no call is active.
Loopback
Loopback is turned on in the test menu.
Modem Ring
Incoming analog modem call is ringing on port. Async-232 port will toggle RI.
Modem Answer
The DTE has answered an incoming analog modem call.
Modem Dial
The DTE is using the Async-232 port to make an outgoing analog modem call.
Modem Connected
An analog modem call has been established.
ISDN PPP Ring
Incoming ISDN PPP call is ringing on the port. Async-232 port will toggle RI.
ISDN PPP Answer
The DTE has answered an incoming ISDN PPP call.
ISDN PPP Dial
The DTE is using the Async-232 port to make an outgoing ISDN PPP call.
ISDN PPP
Connected
An ISDN PPP call has been established.