Instruction manual

ATLAS 800 Series System Manual Nx 56/64 BONDing Resource Module

Configuration

TXFA Timer (sec) Specifies the length of time both endpoints attempt to detect the BONDING

frame pattern when a call is connected before deciding the BONDING call has

failed. When interoperating with other manufacturers' BONDING equipment, it

may be necessary to change this time so that it matches

TXADD01.

TXADD01 Timer (sec) Specifies the length of time both endpoints wait for additional calls to be

connected at the end of negotiation before deciding that the BONDING call has

failed. The factory default setting is sufficient for most calls to connect,

although when dialing overseas it may be necessary to lengthen this timer to

allow for slower call routing.

TXDEQ Timer (sec) Specifies the length of time both endpoints attempt to equalize the network

delay between the bearer channels before deciding the BONDING call has

failed.

TANULL Timer (sec) Specifies the length of time the answering endpoint attempts to detect the

BONDING negotiation pattern from the originating endpoint before deciding

the BONDING call has failed. It may be necessary to shorten this timer if the

DTE equipment using the BONDING module also has timer constraints for

completing non-BONDING parameter negotiation.

TCID Timer (sec) Specifies the length of time both endpoints attempt to negotiate an agreeable

value for bearer channels and channel capacities before deciding the BONDING

call has failed.

Call Stagger Specifies the amount of delay between placing calls for outgoing BONDING

sessions. The following call stagger values are available:

Option Description

No Stagger

There is no delay between the call dialing of a BONDING session.

500 ms

Wait approximately ½ second between the call dialing of a BONDING session.

1 sec.

Wait approximately 1 second between the call dialing of a BONDING session.

2 sec.

Wait approximately 2 seconds between the call dialing of a BONDING session.