Instruction manual

ATLAS 800 Series System Manual NxT1 HSSI Option Module

Info

NXT1 HSSI OPTION MODULE

The NxT1 HSSI/V.35 Module (P/N 1200771L1) system controller automatically detects the presence of

the NxT1 HSSI Option Module when it is installed in the system (listed as

NXT1 HSSI). To see the menus

for the NxT1 HSSI Option Module via the terminal menu, use the arrow keys to scroll to the

MODULES

menu and press <Enter> to access the module choices. V.35 is available when using the optional adapter

cable (ADTRAN P/N 3125I081). The following menu tree shows the hierarchy of the menus discussed in

this section.

(Some of the following menus do not apply when configured for V.35 mode.)

Info

Read security: 5

Provides information about the module part number, serial number, and board revision.

Part Number Displays the part number of the module.

Serial Number Displays the serial number of the module.

Board Revision Displays the board revision of the installed module.

Firmware Revision Displays the firmware revision of the installed module.

T1 Enable

Write Security: 3; Read Security: 5

Configures the NxT1 HSSI Option Module to activate the module’s four built-in T1 interfaces. When

configuring the module to use more than four T1s from other installed T1/T3 modules, set this field to

DISABLED.

The NxT1 HSSI/V.35 Module’s four built-in T1 interfaces are activated collectively as a

bundle. Setting the T1 E

NABLE menu to ENABLED allows you to map any/all of the

built-in T1 ports to the HSSI interface. Setting the T1 E

NABLE menu to DISABLED

requires ALL of the T1s mapped to the HSSI interface to be from other installed T1/T3

modules.

Info T1 Enable T1 Menus IMUX Menus HSSI/V.35 Menus

Part Number Alarm Status Status Status

Serial Number Performance (Curr, 15 min, 24 hr) Port Status Config

Board Revision Configuration Config Test

Firmware Revision Test Test

Port Test