Instruction manual

ATLAS 800 Series System Manual System Utility Menu Descriptions

Force Controller Switch (ATLAS 890)

Write security: 0; Read security: 0

Forces the switch from active to standby to occur immediately.

Reboot System

Write security: 0; Read security: 0

Reboots the ATLAS 800 Series system. When you select this command, the following message displays:

** WARNING ** This will reboot the entire system and service will be interrupted!

Press

Y to reboot the system or N to cancel the command.

Factory Default System

Write security: 0; Read security: 0

Resets the entire system to the factory default settings. To reset the system, press Y. To cancel this

command, press

N. When you select this command, the following message displays:

Alarm Relay Test (ATLAS 890)

Write security: 5; Read security: 5

TOGGLE TEST MODE / TOGGLE set the amount of time for which the alarm relay test mode is active. Change

the amount of time by placing the cursor over the

TOGGLE field and pressing the “.” key to increases the

amount of test time and the “,” key to decreases the amount of test time. The displayed time is in seconds.

This will delete all configuration settings. ADTRAN recommends making a backup

copy of the configuration before defaulting the system.