Specifications

61
THE AUTOPILOT STEERS
POORLY ON ALL
COURSES.
Watch the card on the autopilot compass to make sure that
it follows the vessel’s movements properly. If the card
seems to turn with the vessel for a few degrees, and then
come free, either the pivot or jewel in the compass may be
defective.
THE REMOTE CONTROL
DOES NOT WORK AT ALL.
Check the 'Remote in Command' point to see if the remote
is in control.
Check very carefully that the wires are inserted into the
terminal block in the remote control in the correct order, and
not in reversed order.
THE RUDDER DOES NOT
ALWAYS MOVE EVEN
THOUGH THE PORT OR
STARBOARD OUTPUT LED
IS LIT ON THE AUTOPILOT
FRONT PANEL AND THE
AUTOPILOT IS USING A
CT1 DRIVE BOX.
Recheck all the connections between the autopilot and the
drive box, making sure that none are interchanged.
Remove the cover of the CT1 Motor Drive Box and check
the setting of the minimum speed potentiometer for too low
a minimum speed.
THE RUDDER LIMITS DO
NOT SEEM TO BE
CORRECTLY SET AND THE
AUTOPILOT IS USING A
CT2 DRIVE BOX.
Make sure that there is
NO
connection between the COM
terminal in the Drive Box and any terminal in the autopilot
Distribution Box.