Specifications

54
COMNAV 211 REMOTE CONTROL
This remote control plugs into the remote
receptacle on the rear of the autopilot.
Control is taken at the remote by
pressing both its pushbuttons for one
second. The decimal point on the 1001
Control Head display will move to the
REMOTE
position and the decimal point
on the 211 Remote display will move to
REM.1
.
The
Standby
mode is a safety feature
that allows the remote station to de-
activate the autopilot output to the
steering drive unit. When the switch is in
the
TILLER
position, the vessel's rudder
will be turned to the same angle as
indicated by the control knob.
To lock the vessel onto a heading under
autopilot control, point the vessel onto a
desired heading, and then place the
switch in the
PILOT
position. The
pushbuttons can be used to alter the
vessel's heading in one-degree steps, or
by 10 degrees per second after holding
the pushbutton for half a second.
The
DODGE
/
U-TURN
toggle switch
operates identically to the COMNAV 101
remote.
Fi
g
ure 12 - 211 Remote Control