Specifications

53
COMNAV 201 REMOTE CONTROL
This remote control plugs into the remote
receptacle on the rear of the autopilot.
Control is taken at the remote by
pressing both its pushbuttons for one
second. The decimal point on the 1001
Control Head display will move to the
REMOTE
position. The
Standby
mode is
a safety feature that allows the remote
station to de-activate the autopilot output
to the steering drive unit. When the
switch is in the
TILLER
position, the
vessel's rudder will be turned to the same
angle as indicated by the control knob.
To lock the vessel onto a heading under
autopilot control, point the vessel onto a
desired heading, and then place the
switch in the
PILOT
position. The
pushbuttons can be used to alter the
vessel's heading in one-degree steps, or
by 10 degrees per second after holding
the pushbutton for half a second.
Fi
g
ure 11- 201 Remote Control