Specifications

45
TO CHANGE THE VESSEL'S COURSE
BY ONE DEGREE
, press and release
the red or green
ARROW
key.
TO MAKE LARGER COURSE
CHANGES
, press and hold the red or
green
ARROW
key, and the display will
move at 10 degrees per second until you
release the key. The autopilot will bring
the vessel around to the new course at
the rate set by the Turn Rate control
(see
5)
.
The Function Indicator will show a
'c'
until the course change is complete.
Press the
TURN
key followed by either
the red or green
ARROW
key and the
vessel will make an Emergency turn,
Continuous turn, or U-turn (selected in
STANDBY
) in that direction at the
programmed rate of turn.
The Function Indicator will show a 'E', 'C'
or 'U' until the turn is complete.
If a Navigation Device which transmits
any of the
RMA, RMC, VBW, VHW, or
VTG
sentences is connected to the
autopilot, you may choose automatic
switching between the FAST and SLOW
modes when in Pilot or Nav This works
best if the Navigation Device is a GPS or
a plotter which is driven by a GPS.
THE SPEED SENSITIVITY IS TURNED
ON
by rotating the master select switch
to the STANDBY position and pressing
the ADJUST key once. The display will
change to show
'SP: 0'
.
Press the up ARROW key until the
speed at which you would like the
autopilot to switch from SLOW to FAST
is displayed. When the vessel's speed is
one knot or more higher than this speed,
the autopilot will switch from SLOW to
FAST. When the vessel's speed is one
knot or more lower than this speed, the
autopilot will switch from FAST to SLOW.
THE SPEED SENSITIVITY IS TURNED
OFF
by either manually switching the
autopilot from SLOW to FAST, from
FAST to SLOW, or by rotating the
master select switch to STANDBY and
pressing the ADJUST key once. The
display will change to show
'SP: x'
.
Press the down ARROW key until the
display shows
'SP: 0'
.
If the autopilot fails to receive any speed
information from the navigation device, it
will alarm and display
'NO:SP'
once
every twenty seconds.
The
ADJUST
key can now be used to
adjust the Rudder, Counter Rudder, Yaw
or Turn Rate settings for either the FAST
or SLOW mode.
If the vessel is travelling at high speed,
press the
ADJUST
key once followed by
either the up or down
ARROW
key until
the display reads 'FAST'.
This will occur
automatically if the speed sensitivity is
turned on.
TO INCREASE OR DECREASE THE
RUDDER SETTING
, press the
ADJUST
key until the display reads 'rud' followed
by either the up or down
ARROW
key.
TO INCREASE OR DECREASE THE
COUNTER RUDDER SETTING
, press
the
ADJUST
key until the display reads
'Ctr' followed by either the up or down
ARROW
key.
TO INCREASE OR DECREASE THE
YAW SETTING
, press the
ADJUST
key
until the display reads 'YAW' followed by
either the up or down
ARROW
key.
TO INCREASE OR DECREASE THE
TURN RATE SETTING
, press the
ADJUST
key until the display reads 'trn'
followed by the up or down
ARROW
key.